A control mode was saved with a setting outside boiler guidance: the conductivity change it accepts per sample exceeds 1000 µS/cm.
| At a glance | |
|---|---|
| Code | 220 |
| Shown as | Profile Warning |
| Severity | Info |
| Category | 2xx — Control-loop safety and policy |
| Clears | On the next save, once the setting is back within guidance |
On a boiler profile, the controller checks a mode’s rate-of-change limit against its sample interval. The save went through; this is a heads-up that the tolerance is wider than a boiler normally expects.
Nothing — the saved settings are used as they are.