Which relay, outlet, or pump output drives which piece of equipment, and which control mode owns it. Fill it in when outputs are wired, and update it whenever one changes. Tape a copy inside the panel door.
Label both ends. Write the output name on the equipment’s cord or cable as well as on this sheet — the sheet gets lost, the label stays put.
| Site / system | |
| Controller | |
| Updated by, date |
Device is the output device: a Legacy Relay Device 6 (give its Modbus address), a Wireless Relay Strip or Expander (the name on the controller), or a NextStep pump.
| Device | Output (relay / outlet no.) | Label on the controller | Drives (equipment, make and model) | Load (A or W) | Safe state | Control mode | Interlocks |
|---|---|---|---|---|---|---|---|
| Off | |||||||
| Off | |||||||
| Off | |||||||
| Off | |||||||
| Off | |||||||
| Off | |||||||
| Off | |||||||
| Off |
Safe state is where the output goes when its mode stops or loses a device — normally Off. Note any output that must fail the other way, and why.